Connecting To A Non-Dhcp Network (Static Ip); Troubleshooting The Network Connection - Datavideo HS-3200 Instruction Manual

Connecting to a NON-DHCP Network (Static IP)

Upon connection to a non-DHCP network, the NVS-31 will not be assigned of any IP
addresses. As such it is recommended that you manually assign a fixed IP address to the
device or use the default IP address (192.168.1.60).
Default Fixed IP
Default Fixed IP is primarily used in point-to-point connection, such as connecting the PC to
the NVS-31 directly. In a non-DHCP environment, the NVS-31 works in fixed IP mode only.
To configure the NVS-31 to the default IP, please follow the steps outlined below:
1. Connect the NVS-31's stream port to the network via an Ethernet cable.
2. Turn on the HS-3200's power and the NVS-31 will also be turned ON in
the DHCP mode by default.
3. Search for the NVS-31 device according to the method as detailed in
the previous DHCP section. Once found, log into the user interface on the web browser.
4. Enter the system page by clicking the
"System" tab on the home of the user
interface.
5. In the "Network Setting", disable the DHCP
mode.
6. You will then be allowed to manually enter the static IP address once the DHCP mode is
disabled. The static IP is 192.168.1.60 by default. The subnet mask and default gateway
are 255.255.255.0 and 192.168.1.254 respectively.
Tip: If you forget or lose the IP address, do the following to reset the network settings.
 Turn off the switcher.
 Press the RECORD and STREAM buttons at the same time then turn ON the power of the
switcher
 Wait for about five seconds and release the button push as soon as you see the RECORD
and STREAM button LEDs light up.
 The IP address should be the default IP which is 192.168.1.30.

Troubleshooting the Network Connection

Connect the NVS-31 to the network and open the IP Finder utility program. Scan for the
device. If not found, it is possible that your network is not assigning IP addresses. Reasons of
this are outlined as follows:
 Router or DHCP server is not connected to the network.
 New devices are blocked by the network administrator.
 Anti-virus software or the firewall blocks the communication.
Solve the problem by trying the following:
 Turn off the router, wait for 10 seconds then turn on the router again.
115