Start; Transition; Type - Datavideo HS-3200 Instruction Manual

4.1 Start

The Start menu allows the user to set the transition time, the transition type as well as
various wipe effects. The menu options are shown below.
Advanced mode
Start
Basic mode
Start

Transition

The Transition option allows the user to set the transition duration, in frames, for switching
the PGM view when using the AUTO, DSK and FTB buttons.
For example, if the M/E is set to a value of 50, then the transition will take effect over a
period of 50 frames or roughly 2 seconds. When the AUTO button is pressed, the transition
will take the current M/E value defined by the user setting.

Type

The HS-3200 provides three major types of transition effect, which are DVE (3D), MIX, WIPE
(2D) and Clip. Please note in addition to selecting the transition effect on the OSD menu,
you can also press MIX button, WIPE/DVE button or CLIP button to enable the respective
transition effects.
 If DVE is selected, select the corresponding 3D WIPE effect by pressing the DVE
buttons on the control panel. These DVE buttons are:
DVE 1: Wipe from left to right
DVE 2: Wipe from top to bottom
DVE 3: Wipe from right to left
 For MIX effect, set the transition time in "Start  Transition  M/E."
 For WIPE effect, set the relevant WIPE settings in "Start  WIPE Effects."
 For Clip, also known as the Stinger Effect, please first load the clip in "Files  Clip."
Transition M/E
Type
Wipe Effects Wipe
Border Luma
Position X
Matte Luma
Transition M/E
Wipe Effects Wipe
41
15 DSK
MIX
1 Soft
100% Sat
0% Y
100% Sat
15 DSK
1 Soft
15 FTB 60
0% Width 1%
80% Hue 0
0%
80% Hue 0
15 FTB 60
0% Width 1%