Chapter 3 Network And Software Setup For Switcher; Static Ip Configuration - Datavideo HS-3200 Instruction Manual

Chapter 3
Switcher
The Ethernet port on the back panel of the HS-3200 allows the user to import still images,
clips for stinger transition, still logos, animated logos or user memories using the Switcher
Image Import/Export software. This chapter discusses direct connection between the HS-
3200 and your Windows computer as well as the remote setup in detail. Please download
the Switcher Image Import/Export software to your PC or laptop from the product page
(https://www.datavideo.com/tw/product/HS-3200) before using this feature.
Section 3.1 discusses how you can establish direct connection between the HS-3200 and a
Windows computer. In Section 3.2, we will show you how to access the HS-3200 remotely
on your PC or laptop with the Switcher Image Import/Export software.

3.1 Static IP Configuration

When new from the factory the HS-3200 will initially have a static IP address of
192.168.100.101. The unit can be directly connected to a Windows-based computer using
an RJ-45 ethernet cable. The following set up should allow you to initially configure the
unit's static IP settings.
System requirements and setup are provided as follows:
 An RJ-45 Ethernet cable.
 Windows 7/8/10 laptop or PC.
 The Datavideo Switcher Image
Import/Export software.
Instructions
1. First physically connect the HS-3200 to a Windows computer using an RJ-45 Ethernet
cable.
2. Turn on the Windows computer and set it to static IP setup within the Windows
Network and Sharing Centre. In our example, the computer is given the following IP
settings so that the computer matches the same IP range as the switcher.
Network and Software Setup for
22