Open Switcher Image Import/Export Software - Datavideo HS-3200 Instruction Manual

3. Press the MENU button on the HS-3200 control panel to open the OSD menu on the
connected Multiview monitor. Open the OSD menu  Setup  Network and then
change the Addr Mode to DHCP from the default Static IP. Move to the SAVE option and
press the ENTER button to save new settings.
4. Reboot the HS-3200 and after the machine is rebooted, open the Network sub menu by
following the instructions outlined in the previous step. The IP Addr option should show
an IP address assigned randomly by the router thus having the same IP range as the
router. If you see an IP address of 0.0.0.0 in the IP Addr field, it is likely that the router
requires longer time to assign an IP address to the connected devices. Close the
Network sub menu and reopen after 30-60 seconds, you should be able to see the
newly assigned IP address. If problems still exist, contact any IT specialists for assistance.

3.3 Open Switcher Image Import/Export Software

After configuring your connection mode, download and unzip the Switcher Image
Import/Export software then in the unzipped folder, double click the software icon to open
the program.
The Switcher Image Import/Export software has a built-in IP finder, which is designed for
PC with multiple Ethernet cards or DHCP network environment. Upon launch of the
Switcher Image Import/Export software, you will be prompted to select one Ethernet
Interface Card. Please note that the IP finder can only find devices connected to the same
network as the PC.
Once selected, click OK to start the scanning process.
Note: Please make sure the selected interface card is on the same network as the HS-3200
device.
Once the HS-3200 device is found, the software will connect with the switcher over the IP
set up described in the previous section. If the connection is successfully established, on the
software user interface as shown in the diagram below, the Connect Status will show
"Connected" (will display Not Connected if disconnected).
Brief descriptions of buttons on the MENU SELECT pane are outlined as follows:

Home: Interface main page showing connection status and transition time settings.

User: User memory import

Still: Still image import
25