Standard; Genlock; Outconv; Menu Mode - Datavideo HS-3200 Instruction Manual

Network Mask

Standard

This option allows the user to choose the appropriate output resolution such as 1080i/50.
Once done, simply select "Save" to confirm the selected output resolution. The available
resolutions are 1080p/60/59.94/50, 1080i/60/59.94/50, and 720p/60/59.94/50.
The menu option OutConv will be activated as soon as 1080p50 or 1080p59 is selected.
OutConv allows you to downgrade the resolution of the SDI video port 5. See the section,
OutConv, for details of this option.
Level
There are two different audio standards available for selection. The user can either select
the EBU or SMPTE standard. By selecting AUTO allows the device to automatically detect
the audio standard.
Note: When the image is 50 Hz, the audio follows EBU standard and when the image is
59.94/60 Hz, the audio follows SMPTE standard.

Genlock

Genlock is an external sync setting. Ref IN/OUT port receives external sync which can be
either Tri-Level or Black Burst signal. Enable genlock to allow the switcher to receive
external sync, then adjust its H and V phases accordingly.
H phase ranges from -2190 to +2190 ms and V phase ranges between -1124 and +1124. A
positive value sets sync signal leading and a negative value sets sync signal lagging.

OutConv

When the video output resolution is set to 1080p50 or 1080p59, OutConv allows you to
downconvert the resolution of SDI video port 5.
If the output resolution is 1080p50, you may downconvert the resolution to the following:
 Off
 720p50
 1080i50
If the output resolution is 1080p59.94, you may downconvert the resolution to the following:
 Off
 720p59.94
 1080i59.94

Menu Mode

The user is allowed to switch between full and simplified menu versions. Select "Advanced"
for full menu display or "Basic" to display a condensed version of the OSD menu.
255 255
Cancel
255
Save
69
0