1.
Open the CG settings page.
2.
Enable the CG function.
3.
In the Text field, enter the overlay text.
4.
Enter the X and Y coordinates to set the text position.
5.
Click the Apply button to save the new settings.
Note: Increasing the X coordinate moves the overlay text to the right and decreasing the X
coordinate moves the overlay text to the left; increasing the Y coordinate moves the
overlay text up and decreasing the Y coordinate moves the overlay text down.
7.4 Stream and Record Buttons
RECORD Button
Record function in
Solid White
idle state
Record function is
Blinking Red
activating or
resetting
Record function
Solid Red
activated
Record Button
Start recording
When idle, the RECORD button is solid white.
Press and hold the RECORD button for approximately 2 seconds.
When the record function is activating, the RECORD button turns from solid white,
then blinking red and finally to solid red.
When the RECORD button is solid red, this indicates that the record function has
been successfully activated.
Note: The RECORD button is disabled in the Stream Only mode.
Stop recording
While recording, the RECORD button is solid red.
Press and hold the RECORD button for approximately 2 seconds.
The RECORD and STREAM buttons on the front panel of the HS-
1300 give the user certain controls of the record and stream
functions. In this section, we will cover operations of these two
buttons in detail.
Button LED behaviors and their corresponding states are listed in
the table below:
STREAM Button
Stream function in
idle state
Stream function is
activating or
resetting
Stream function
activated
148
RECORD+STREAM Button
Record/Stream functions in
idle state simultaneously
Record/Stream functions
are activating or resetting
simultaneously
Record/Stream functions
are activated simultaneously