Connecting To A Non-Dhcp Network (Static Ip); Default Fixed Ip; Troubleshooting The Network Connection - Datavideo HS-1600T MKII Instruction Manual

Connecting to a NON-DHCP Network (Static IP)

Upon connection to a non-DHCP network, the NVS-31 MARK II will not be assigned of any IP addresses.
As such it is recommended that you manually assign a fixed IP address to the device or use the default
IP address (192.168.1.60).

Default Fixed IP

Default Fixed IP is primarily used in point-to-point connection, such as connecting the PC to the NVS-
31 MARK II directly. In a non-DHCP environment, the NVS-31 MARK II works in fixed IP mode only. To
configure the NVS-31 MARK II to the default IP, please follow the steps outlined below:
1. Connect the NVS-31 MARK II's stream port to the network via an Ethernet cable.
2. Turn on the HS-1600T MKII's power and the NVS-31 MARK II will also be turned ON in
the DHCP mode by default.
3. Search for the NVS-31 MARK II device according to the method as detailed in the
previous DHCP section. Once found, log into the user interface on the web browser.
4. Open the system page by clicking the "System"
tab on the home of the user interface.
5. In the "Network Setting", disable the DHCP
mode.
6. You will then be allowed to manually enter
the static IP address once the DHCP mode is disabled. The static IP is 192.168.1.60 by default. The
subnet mask and default gateway are 255.255.255.0 and 192.168.1.254 respectively.
Tip: If you forget or lose the IP address, do the following to reset the network settings.
 Turn off the device.
 Press the RECORD and STREAM buttons at the same time then turn ON the power of the
device
 Wait for about five seconds and release the button push as soon as you see the RECORD and
STREAM button LEDs light up.
 The IP address should be the default IP which is 192.168.1.60.

Troubleshooting the Network Connection

Connect the NVS-31 MARK II to the network and open the IP Finder utility program. Scan for the
device. If not found, it is possible that your network is not assigning IP addresses. Reasons of this are
listed as follows:
 Router or DHCP server is not connected to the network.
 New devices are blocked by the network administrator.
 Anti-virus software or the firewall blocks the communication.
Solve the problem by attempting the following:
 Turn off the router, wait for 10 seconds then turn on the router again.
 Reset the NVS-31 MARK II to the factory default:
-
Turn off the device.
41