Bitrate Button
Follow the steps below to switch the stream bitrate mode using the BITRATE button:
Press and hold one of the RECORD+STREAM button, the RECORD button, and the
STREAM button until the pressed button starts blinking red.
Continue holding down one of the RECORD+STREAM button, the RECORD button,
and the STREAM button while pressing the BITRATE button to switch stream bitrate
mode (H, M or L).
Note: The system will return to original settings if the BITRATE button push is not sensed.
The default bitrate is M.
Operation Mode
Checking the NVS-31's operation mode
Follow the steps below to check the NVS-31's current operation mode:
First make sure the stream and record functions are in idle state, i.e. STREAM and
RECORD buttons are solid white.
Press RECORD or STREAM button.
The button LED should behave according to the device's operation mode. The LED
behaviors are summarized in the table below:
Solid red STREAM button
Solid white STREAM
button
The two buttons turn solid white a few seconds after displaying the operation mode.
Switching operation modes
Follow the steps below to switch to the next operation mode:
First make sure the stream and record functions are in idle state, i.e. STREAM and
RECORD buttons are solid white.
Simultaneously press and hold the RECORD and STREAM buttons for more than 3
seconds but less than 10 seconds.
As the operation mode switches, both the RECORD and STREAM buttons turn from
solid red, then blinking red and finally to solid white.
When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-
31 has been switched to the next operation mode successfully.
Note: The order of the operation mode change is Stream & Record Stream Only
Record Only
Solid red RECORD
button
Stream & Record
Record Only Mode
150
Solid white RECORD
button
Stream Only Mode
None