Importing Still Logo From Pc - Datavideo HS-3200 Instruction Manual

the Preview and Program Out. Follow the steps outlined below to load the desired still logo
from memory.
Files File Type
Load Logo
On the still logo menu, you should find a thumbnail view of three logos. Use the up/down
arrow buttons to browse all other logos which are shown in numerical order. Black
thumbnails are unused memory slots.
To load a still logo, simply browse to a still logo number and select a logo buffer then select
'Load'. The selected still logo will be loaded into the selected buffer. In the above example,
logo 1 will be loaded with the logo saved in memory slot 13.
To adjust the logo position, simply change the X and Y values of the respective logo buffer
which can be found at the bottom of the Logo menu.
Selecting "Clear Logo" clears the logo buffer. Selection of "Delete Logo" removes the logo
from the selected memory slot.

Importing Still Logo from PC

The Switcher Image Import/Export software (SwitcherImageImEx_vx.x.x.msi) allows the
user to import still logos from the PC to a designated memory slot of the switcher. The
software installation package can be downloaded from the product page.
Note: A standard still logo is basically a still picture with an aspect ratio limited to
480x1080.
See Chapter 3 for installation instructions and network configuration.
How to use
1. Open the Switcher Image Import/Export Program and make sure the Connect Status
shows "Connected" (shows Not Connected if disconnected).
Logo
Load
Thumbnail
Picture – 1
Clear Logo
Logo 1 X
Logo 2 Y
Logo
Thumbnail
Picture
-37% X
0% Y
91
13 Logo 1
Thumbnail
Picture + 1
Delete Logo
24%
0%