Table of Contents
Advertisement
Copyright © 2017, Juniper Networks, Inc.
CAUTION:
Before front-mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
Install the winch strap plate to the rear of the router by tightening the four captive
1.
screws (see
Figure 23 on page
Figure 23: Installing the Winch Strap Plate (Four-Post Rack)
Using a four-person team, transport the router to the rack installation location and
2.
center it in front of the mounting shelf.
NOTE:
A minimum of 38 in. (96.5 cm) of clearance is required to roll the chassis
sideways.
A minimum of 42 in. (106.7 cm) of circular space is required to rotate
the chassis.
The router transport kit handles can be removed to accommodate aisle
width.
Install the winch mount bracket to the rear rack rails by using the six captive screws,
3.
and tighten the screws (see
Use the Router Transport Kit to Install the Router in a Four-Post Rack
31).
Figure 24 on page
32).
31
Advertisement
Table of Contents
