Juniper MX2008 Quick Start Manual page 46

3d universal edge router

Hide thumbs Also See for MX2008:

Table of Contents

MX2008 3D Universal Edge Router Quick Start

Connect the wires to the AC terminal block on the three-phase delta AC PDM (see

11.

Figure 34 on page

46). Loosen the input terminal or grounding point screw, insert each

wire into the grounding point input terminal, and tighten the screw (see

Table 4 on page 47

for approved AC wire gauge).

NOTE:

The terminal connections have either slotted screws or hex screws.

Use a 1/4-in. slotted screwdriver for the slotted screws. Use a 5/32-in.

(4-mm) Allen wrench for the 5/16-in. hex screws.

NOTE:

The three-phase delta AC PDM must be installed and secured in

the chassis before connecting the power input cables. If the PDM must

be removed, both input power cables must be uninstalled and removed

from the PDM before the PDM can be removed from the chassis. The

MX2008 chassis is not sensitive to phase rotation sequence—either

clockwise or counter clockwise will operate correctly.

To connect wires to the terminal block that serves six PSMs:

a. Insert the grounding wire into the grounding point labeled

b. Insert the wire labeled

c. Insert the wire labeled

d. Insert the wire labeled

Figure 34: Connecting Power to a Three-Phase Delta AC Power Distribution

Module

into the input terminal labeled

GND

Table of Contents