Table of Contents
Advertisement
MX2008 3D Universal Edge Router Quick Start
14
NOTE:
The router is maximally protected inside the shipping crate (see
Figure 7 on page
Figure 7: MX2008 Shipping Crate Door
To unpack the router:
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the shipping pallet, you can use a forklift or pallet jack to move it.
NOTE:
The staging and installation area must be ESD-approved.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate and set it aside.
4.
Using a two-person team, slide the remainder of the shipping crate off the pallet.
5.
Remove the foam covering the top of the router.
6.
Remove the pallet jack attachment, if ordered.
7.
NOTE:
If you ordered a router transport kit, see
Transport Kit" on page 24
the router transport kit.
14). Do not unpack it until you are ready to begin installation.
for instructions on how to unpack and install
"Unpack the Router
Copyright © 2017, Juniper Networks, Inc.
Advertisement
Table of Contents
