Juniper MX2008 Quick Start Manual page 54

MX2008 3D Universal Edge Router Quick Start
54
Verify that the
8. PWR OK
about MX2008 AC PSM LEDs.
NOTE: The MX2008 systems configured for three-phase wye AC input
power must use only three-phase wye AC PDMs and AC PSMs. Systems
configured for three-phase delta AC input power must use three-phase
delta AC PDMs and AC PSMs. AC and DC PSMs or PDMs must not be
mixed within a single system.
Table 8: MX2008 AC Power Supply Module LEDs
Label Color
Green
PWR OK
Yellow
–
Red
FAULT
–
Green
INP0
Yellow
–
Green
INP1
Yellow
–
Repeat Steps 1 through
9.
LED is lit green steadily. See
State Description
On Power is functioning normally with no alarms.
On PSM controller is off with both
voltage out of range.
Off PSM is not functioning normally or the AC input
voltage is out of range.
On PSM is not functioning normally or the AC input
voltage is out of range.
Off PSM is functioning normally.
On AC input is within the required voltage range and
the DIP switch is set to on.
On AC input is out of the required voltage range.
Off AC input to the PSM is not present.
On AC input is within the required voltage range and
the DIP switch is set to on.
On AC input is out of the required voltage range.
Off AC input to the PSM is not present.
8 for installing PSMs in slots
Table 8 on page 54 for information
INP0 and INP1
, , and , where required.
0 1 2
Copyright © 2017, Juniper Networks, Inc.