Table of Contents
Advertisement
Copyright © 2017, Juniper Networks, Inc.
Remove the shipping brackets that are attached to the pallet jack attachment and
10.
chassis, and set them aside.
Grasp the handles on the shipping covers and carefully slide the router into the rack.
11.
If you are installing the router into a four-post rack, continue sliding the router onto
the mounting shelf so that the bottom of the chassis and the mounting shelf overlap
by approximately 2 in. (5.0 cm).
With four people pushing on the front-mounting flanges, slide the router until the
12.
center-mounting brackets (open-frame racks) or front-mounting flanges (four-post
racks) contact the rack rails. In a four-post rack, the mounting shelf ensures that the
holes in the front-mounting flanges of the chassis align with the holes in the rack rails
(see and
Figure 14 on page 23
Move the pallet jack away from the rack.
13.
Insert twelve mounting screws (six on each side) into the mounting holes to secure
14.
the router to the rack.
Visually inspect the alignment of the router. If the router is installed properly in the
15.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side, and the router should be level.
Figure 14: Loading the MX2008 Router into a Four-Post Rack
Use the Pallet Jack with Attachment to Install the Router
and
Figure 15 on page
24).
23
Advertisement
Table of Contents
