RS 125
7.4.9.
SIDE STAND REMOVAL
TORQUE WRENCH SETTINGS
Screws (1)
Screw (2)
Stand bracket bolts (3)
Stand switch screw
Stand pivot bolt
•
Place the motorcycle on the rear wheel stand (OPT);
see
1.7.2.
•
Lower the side stand.
•
Release and remove the two screws (1).
•
Release and remove the screw (2).
•
Remove the fairing cover.
•
Disconnect the side stand connector on the right side
of the motorcycle.
•
Release and remove the two bolts (3) and collect the
nuts at the opposite end.
•
Remove the side stand complete with switch and
bracket.
2 Nm (0.2 Kgm)
3 Nm (0.3 Kgm)
22 Nm (2.2 Kgm)
10 Nm (1.0 Kgm)
10 Nm (1.0 Kgm)
CHASSIS
7 - 53