APRILIA RS 125 Manual page 29

RS 125
NOTE If present, remove the application tape (5) 20 to 30
minutes after applying the decal.
•
Remove the application tape (5) from the decal
surface.
•
To ensure a good adhesion, use the spatule again by
taking special care to the corners and edges.
NOTE When using the wet method, the decal final adhesion
level will be reached around 48 hours after the application.
•
After having removed the application tape, make sure
that no blisters are present on the surface.
Should some blisters be present, proceed as follows:
•
Using a pin or a cutter (6) cut the blister (7).
•
Use the spatule (1) starting from the side opposite to
the cut and press the blister to make the air come out.
The application tape is used to make the makes and letters
application easier, namely to position them correctly on the
surface you wish to decorate and to reinforce the adhesive
during application.
GENERAL INFORMATION
5
6
7
1 - 23