CHASSIS
7.3.
CONTROLS
7.3.1.
REMOVING THE THROTTLE CONTROL
Read
1.2.1
carefully.
TORQUE WRENCH SETTINGS
Screws (1)
Screws (3)
•
Release and remove the two screws (1) securing the
two shells from the bottom.
•
Separate the two shells.
WARNING
On refitting, position the bottom shell first,
making sure the locating peg becomes fully
seated into the handlebar hole.
•
Disconnect the throttle cable (2).
•
Unscrew the screw (3) and remove the counterweight.
•
Slide the twistgrip off the handlebar. Use an air gun to
aid removal.
•
Slide the throttle control off the handlebar.
NOTE Check throttle cable free play on refitting and adjust
as required; see
2.15.1.
7 - 38
3 Nm (0.3 kgm)
10 Nm (1.0 kgm)
RS 125