RS 125
2.17.3.
REAR SWINGING ARM ADJUSTMENT
Read
1.2.1
carefully.
TORQUE WRENCH SETTINGS
Spindle (1)
Lockring (2)
Lockring adjusting bush (3) 12 Nm (1.2 kgm).
•
Put the motorcycle on the front wheel stand (OPT),
1.7.1.
•
Remove the fuel tank; see
•
Fix the slings to the frame at the engine top mounting
point.
•
Lift the hoist arm until stretching the slings taut.
•
Slacken the spindle (1) working from the left side.
NOTE Make sure to have the special tool no. 8101945 ready
at hand (socket for swinging arm spindle adjustment).
•
Working from the right-hand side of the motorcycle,
slacken the lockring (2) fully using the special socket.
•
Tighten the adjusting bush (3) to the specified torque.
•
Tighten the locking (2) using the special socket.
•
Tighten the spindle (1).
100 Nm (10.0 kgm).
35 Nm (3.5 kgm).
4.1.1.
ROUTINE MAINTENANCE
2 - 47