Chassis; Removing The Handlebars - APRILIA RS 125 Manual

RS 125
7.4.

CHASSIS

7.4.1.

REMOVING THE HANDLEBARS

Read 1.2.1 carefully.
TORQUE WRENCH SETTINGS
Screw (1)
LEFT HANDLEBAR
•
Slacken the screw (1) and remove the counterweight
(2).
• Fit the nozzle of an air gun between twistgrip (3) and
handlebar.
• Blow while twisting the nozzle tip. At the same time,
grasp the twistgrip (3) with the other hand and pull
outwards to remove.
•
Remove the left light dip switch from the handlebar;
see 7.2.5.
NOTE You need not detach the connector from the wiring.
•
Release and remove the two screws (4).
•
Remove the clamp and move the clutch control aside.
The clutch control is retained by the clutch hose.
•
Release and remove the screw (5).
•
Remove the left handlebar.
RIGHT HANDLEBAR
•
Remove the throttle control; see
• Remove the right light dip switch from the handlebar;
see 7.2.4.
NOTE You need not detach the connector from the wiring.
• Remove the front brake control partially; see
7.3.3.
• Release and remove the screw (6).
•
Remove the right handlebar.
10 Nm (1.0 kgm)
7.3.1.
CHASSIS
7 - 45