COOLING SYSTEM
5.6.
EXPANSION RESERVOIR
5.6.1.
EXPANSION RESERVOIR
TORQUE WRENCH SETTINGS
Expansion reservoir retaining screw (1)
REMOVAL
•
Drain the cooling circuit; see
•
Release and remove the screw (1).
•
Remove the clip (2).
•
Disconnect the tube (3) from the expansion reservoir
(4).
•
Remove the expansion reservoir (4).
WARNING
Store the expansion reservoir (4) in a safe
place.
INSTALLATION
•
Position the expansion reservoir (4).
NOTE Be sure to have the special clip tweezers (no.
0277295) ready at hand and renew all clips using the same
type fitted originally.
•
Refit the tube (3) to the expansion reservoir (4).
•
Tighten the screw (1).
•
Fill the cooling circuit; see
5 - 8
3 Nm (0.3 kgm).
5.2.1.
5.2.1.
RS 125