Table of Contents
Advertisement
Figure 51
1. Bolt
2. Washer
4.
Check the distance between the left and right
bellcranks and the upper frame tube.
Note:
These dimensions need to be the same
on both sides.
5.
To make the distances equal, loosen the
Allen-head bolt on the hub of the right bellcrank
(Figure
52).
6.
Position the bellcrank arms the same distance
from the upper frame tube.
7.
Tighten the Allen-head bolt and install the side
plates.
g007380
3. Side plate
1. Right bellcrank arm
2. Allen-head bolt
Adjusting the Closed Door
for 48- and 52-inch Mowers
1.
Disengage the PTO, move the motion-control
levers to the N
the parking brake.
2.
Stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
With the door closed, check and ensure that it is
slightly tight against the frame when closed.
4.
If adjustment is needed, adjust the nuts.
Note:
Lengthen the links to reduce the force.
Shorten the links to increase the force.
Note:
Make sure that both the left and right
sides are adjusted the same distance. With the
door closed, the links should be slightly tight to
minimize rattling.
5.
Tighten the nuts.
36
Figure 52
3. Distance from the
bellcrank arm and upper
frame tube is the same on
both sides.
4. Upper frame tube
-
position, and set
EUTRAL
LOCKED
g007381
Advertisement
Table of Contents
