Replacing The Blower Belt For 48- And 52-Inch Machines; Checking And Adjusting The Blower Latch - Toro 78562 Manual

1. Spring-loaded idler pulley
2. Short-hook end
7. Pull back on the spring-loaded idler pulley and install
the belt onto the spring-loaded idler pulley
Replacing the Blower Belt for
48- and 52-inch Machines
1. Disengage the PTO, move the motion-control levers
to the N -
EUTRAL LOCKED
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the belt-guide bolt
4. Remove the existing blower belt.
5. Install the new belt around the blower pulley
44).
6. Install the belt between the fixed-idler pulley and the
belt-guide bolt.
7. Tighten the belt-guide bolt
Figure 43
3. Long-hook end
(Figure
position, and set the parking
(Figure 44).
(Figure 44).
1. Idler pulley
2. Mower-deck pulley
3. Spring
4. Spring peg
42).
8. Install the spring as shown in
(Figure
1. Spring-loaded idler pulley
2. Short-hook end
9. Install the belt onto the spring-loaded idler pulley
(Figure
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are adjusted
correctly. Loosen or tighten the bolts so that the latches
firmly hold the blower assembly against the mower deck but
can be released by hand.
25
Figure 44
5. Belt
6. Belt-guide bolt
7. Fixed-idler pulley
8. Blower pulley
Figure
Figure 45
3. Long-hook end
44).
45.