Checking And Adjusting The Blower Latch; Greasing The Idler Arm And Handle Pivot - Toro E-Z Vac DFS 78556 Operator's Manual

Figure 42
1. Idler pulley
2. Mower-deck pulley
3. Spring
4. Spring peg
8. Install the spring as shown in
Figure 43
1. Spring-loaded idler pulley
2. Short-hook end
9. Install the belt onto the spring-loaded idler pulley
(Figure 42).
g003454
5. Belt
6. Belt-guide bolt
7. Fixed-idler pulley
8. Blower pulley
Figure 43.
g003776
3. Long-hook end
Checking and Adjusting the
Blower Latch
Close the blower assembly to see if the latches are
adjusted correctly. Loosen or tighten the bolts so the
latches firmly hold the blower assembly against the
mower deck but can be released by hand.
1. Latch
2. Bolt
Greasing the Idler Arm and
Handle Pivot
Service Interval: Every 50 hours—Grease the idler
arm.
Every 100 hours—Grease the handle pivot.
Grease the blower belt idler arm
33
Figure 44
3. Blower assembly
(Figure 45).
Figure 45
g003400
g003455