Replacing The Blower Belt For 48- And 52-Inch Machines - Toro 78555 Operator's Manual

1. Idler pulley
2. Mower-deck pulley
3. Spring
6. Install the spring as shown in
1. Spring-loaded idler pulley
2. Short-hook end
7. Pull back on the spring-loaded idler pulley and
install the belt onto the spring-loaded idler pulley
(Figure 42).
Replacing the Blower
Belt for 48- and 52-inch
Machines
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
Figure 42
4. Spring peg
5. Belt
6. Blower pulley
Figure 43.
Figure 43
3. Long-hook end
- position, and
LOCKED
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the belt-guide bolt
4. Remove the existing blower belt.
5. Install the new belt around the blower pulley
(Figure 44).
6. Install the belt between the fixed-idler pulley and
the belt-guide bolt.
7. Tighten the belt-guide bolt
g003398
1. Idler pulley
2. Mower-deck pulley
3. Spring
4. Spring peg
8. Install the spring as shown in
g003638
28
(Figure 44).
(Figure 44).
Figure 44
5. Belt
6. Belt-guide bolt
7. Fixed-idler pulley
8. Blower pulley
Figure 45.
g003454