11.
Join the upper and lower tubes with 3 bolts (#10
x 3/4 inches), 3 flat washers (7/32 inch), and 3
locknuts (#10) as shown in
Figure 28
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
12.
Install the lower tube onto the blower housing
and secure it with the latches.
11
Installing the Belt Cover
Parts needed for this procedure:
1
Belt cover (from the Blower and Drive Kit)
Procedure
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Install the new belt cover so that the notches on
both sides go over the belt-cover supports and
secure the latch
(Figure 29
Figure
28.
g003392
4. Locknut (#10)
5. Bolt, (#10 x 3/4 inches)
or
Figure
30).
48- and 52-inch bagger shown
1. Belt cover
2. Belt-cover support
60- and 72-inch bagger shown
1. Belt cover
2. Belt-cover support
22
Figure 29
3. Notch
Figure 30
3. Notch
g009305
g009303