6
Installing the Bagger
Assembly
Parts needed for this procedure:
1
Bagger assembly
2
Pin and hairpin cotter assembly
Procedure
1.
Position the bagger on its back
2.
Slide the hooks onto the lower mounting bracket
(Figure
10).
3.
Rotate the bagger up on the lower bagger
mounting bracket.
4.
Align the hole in the bagger with the upper
mounting bracket
5.
Install the pin and secure it with the hairpin
cotter on both sides
(Figure
10).
(Figure
10).
(Figure
10).
1. Lower mounting bracket
2. Hook
3. Bagger
6.
Rotate the bagger-handle linkage up to the
bagger assembly and secure it with a clevis-pin
spring
(Figure
Note:
Loosen and rotate the yoke if needed to
align it with the bagger assembly.
13
Figure 10
4. Rotate bagger up
5. Hairpin cotter connected
to lanyard
6. Pin connected to lanyard
11).
g009219