Toro E-Z Vac DFS 78556 Operator's Manual page 30

48in, 52in, 60in, or 72in collection system for z master g3 mower
Table of Contents

Advertisement

Reducing Plugging
To avoid plugging the bagging system, reduce
the ground speed and mow the grass at a high
height-of-cut, then lower the mower to your normal
cutting height and repeat the bagging process.
Signs of Plugging
As you use the bagger, a small amount of grass
clippings normally blow out the front of the mower. An
excessive amount of clipping blow-out indicates that
the bagger is full or the tube is plugged.
Bagging Blades
In most mowing conditions, the standard high lift
blades provides the best bagging performance.
The Toro Atomic blade is recommended for bagging
leaves in dry conditions. In dry, dusty conditions, the
medium lift or low lift blades reduces dust and dirt
blowout while providing effective bagging air flow.
Contact an Authorized Service Dealer for the proper
blades for different mowing conditions.
Curb Climbing and Loading
Always lift the deck to the highest position when loading
the machine on trailers or ascending/descending a
curb. Leaving the mower in a lower position while
loading or going over a curb can cause damage to the
mower. If a curb is higher than 152 mm (6 inches),
cross it at a sharp angle with the deck fully raised.
Use extreme caution when loading onto a trailer. Use
a full-width ramp; the ramp should be long enough so
that the angle does not exceed 15 degrees.
30

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-z vac dfs 78566E-z vac dfs 78567

Table of Contents