Toro E-Z Vac DFS 78556 Operator's Manual page 17

2. Slide the blower-assembly peg into the pivot
hole (Figure 16 or
Figure 16
48- and 52-inch mower deck shown
1. Blower assembly
2. Mower deck
Figure 17
60- and 72-inch mower deck shown
1. Blower assembly
2. Mower deck
Figure 17).
3. Pivot hole
4. Blower-assembly peg
3. Pivot hole
4. Blower-assembly peg
3. Close the blower assembly to see if the latches
are adjusted correctly
Note:
Loosen or tighten the bolt so the latches
firmly hold the blower assembly against the
mower deck but can be released by hand
g009420
1. Latch
2. Bolt
4. Install the spring as shown in
Note:
Make sure that the hooks are in the
correct position.
g009220
1. Spring-loaded idler pulley
2. Short-hook end
17
(Figure 18).
Figure 18
3. Blower assembly
Figure 19.
Figure 19
3. Long-hook end
g003400
g003638