Installing The Pulley Assembly, Belt Cover; And Shoulder Bolt; Installing The Attachment Mount - Toro E-Z Vac 79346 Operator's Manual

5
Installing the Pulley
Assembly, Belt Cover,

and Shoulder Bolt

Parts needed for this procedure:
1 Pulley assembly
1 Belt cover
Procedure
1. Remove the nut and washer from the right
mower deck pulley.
2. Install the pulley assembly to the right mower
deck pulley with the previously removed nut and
washer (Figure 11).
Important:
For 48-inch mower decks, use
the small blower pulley.
For 54-inch and 60-inch mower decks, use
the large blower pulley.
3. Torque the nut to 136 to 149 N∙m (100 to 110
ft-lb).
54-inch mower deck shown
1. Existing pulley nut
2. Existing washer
3. Blower pulley
Figure 11
4. Existing deck (spindle)
pulley
5. Spindle
4. Install the new belt cover over the pulley
assembly using the 4 previously removed
screws (1/4 x 1/2 inch) as shown in
1. Belt cover
6
Installing the Attachment
Mount
Parts needed for this procedure:
1 Stabilizer bracket
2 Carriage bolt (5/16 x 3/4 inch)
4 Locknut (5/16 inch)
2
Self-tapping screw (5/16 x 3/4 inch)
2 Bolt (5/16 x 1 inch)
1 Pivot frame
2 Hairpin cotter
2 Rod
2 Washer
g201880
Procedure
1. Remove the existing 2 bolts, 2 nuts, and hitch
bracket from the bottom of the engine guard
(Figure 13).
10
Figure
Figure 12
2. Screw (1/4 x 1/2 inch)
12.
g201435