Installing The Belt Cover; Belt Cover (From Blower And Drive Kit) - Toro 78562 Manual

14. Join the upper and lower tubes with 3 bolts (#10 x
3/4 inches), 3 flat washers (7/32 inch), and 3 locknuts
(#10) as shown in Figure
Figure 30
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
15. Install the lower tube onto the blower housing and
secure it with the latches.
16. Install the bags onto the bagger.
30.
4. Locknut (#10)
5. Bolt (#10 x 3/4 inches)
9

Installing the Belt Cover

Parts needed for this procedure:
1

Belt cover (from Blower and Drive Kit)

Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so that the notches on both
sides go over the belt-cover supports and secure the
latch (Figure 31
48- and 52-inch bagger shown
1. Belt cover
2. Belt-cover support
16
or Figure 32).
1
2
Figure 31
3. Notch
G009305