Installing The Belt Cover; Installing The Weights - Toro 78534 Operator's Manual

Figure 26
1. Lower tube
2. Upper tube
3. Flat washer (7/32 inch)
15. Install the lower tube onto the blower housing and
secure it with the latches.
16. Install the bags onto the bagger.
9

Installing the Belt Cover

Parts needed for this procedure:
1 Belt cover (from the Blower and Drive Kit)
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so the notches on both sides
go over the belt-cover supports and secure the latch
(Figure 27).
4. Locknut (#10)
5. Bolt (#10 x 3/4 inches)
1. Belt cover
2. Blower assembly
3. Pulley assembly
4. Belt-cover bracket
10

Installing the Weights

Parts needed for this procedure:
2
Caster weight
2 U-bolt
4 Nut (1/2 inch)
4 Lock washer (1/2 inch)
2 Plate
2
Top weight (for 60 inch mower decks only)
2 Bolt, 1/2 x 2–1/2 inch- for top weights
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add
weights to the machine.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition that
could result in a loss of control.
1. Place caster weights on the front casters.
15
Figure 27
5. Latch
6. Belt-cover notch
7. Belt-cover support