Preparing The Mower; Installing The Side Bumpers And Support Brackets - Toro Z Master 2000 Series Operator's Manual

Procedure
13
14
Note: Determine the left and right sides of the machine from the normal operating position.
1

Preparing the Mower

No Parts Required
Procedure
Perform the following procedure to prepare the mower for
attaching the blower and bagger kit.
1. Disengage the PTO, move the motion-control levers
to the N locked position, and set the parking
EUTRAL
brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Repair all bent or damaged areas of the mower deck
and replace any missing parts.
4. Clean the mower of any debris on the deck or rear part
of the mower to ease installation.
Description
Weight-mount bracket
Carriage bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Front weight
Bolt (3/8 x 1 inch)
Lock washer
Flat washer
Flange nut (3/8 inch)
No parts required
Qty.
1
2
2
3
Install the weights.
6
6
6
3
–
Check the tire pressure.
2
Installing the Side Bumpers
and Support Brackets
Parts needed for this procedure:
1 Left bumper
1 Left frame-support bracket
1 Right bumper
1 Right frame-support bracket
6 Carriage bolt (3/8 x 1-1/4 inches)
6 Flange nut (3/8 inch)
Procedure
1. Remove the left and right bumpers as follows:
A. Remove the nuts and bolts securing the left side
bumper and muffler shield to the chassis and
center engine guard as shown in
6
Use
Figure 4.