Fujitsu Airstage J-II Series Design & Technical Manual page 868

1-4. TOUCH PANEL CONTROLLER
External input
Control input
Electricity meter
-
-
1-4-1. EXTERNAL INPUT
● This function performs "Emergency stop" or "All On / All Off" by using the signal to be input externally at external
input terminals.
„ INPUT SELECT
„
Use either one of these types of terminal according to the application. (Both types of terminals
cannot be used simultaneously.)
For more details on the selection setting, refer to the operation manual of Touch Panel
Controller.
It is possible to switch to the Dry contact terminal or the Apply voltage terminal by connecting
the CN201 on the TM201 printed circuit board to the CN411 or the CN412 on the printed circuit
board of the panel side.
* The Dry contact terminal (connected to the CN411) is set when shipped from the factory.
TM201 - CH1, CH2
Dry contact terminal
Apply voltage terminal
z Dry contact terminal TM201 (CN411)
„
When a power supply is unnecessary at the input device you want to connect, use the Dry
contact terminal TM201 (CN411).
Connection example 1: When the switch is connected
PCB
*1
*1: Short circuit detection resistance (R
Open circuit detection resistance (R
A twisted pair cable(22AWG) should be used. Maximum length of cable is 82 ft. (25 m)
External output Connector
-
TM201 (CN411 or CN412)
-
Operation status
Error status
Connect with the CN201
CN411
CN412
PCB
TM201
) : ≤ 500 (ohm).
ON
) : ≥ 100 (kilo-ohm).
OFF
- (08 - 48) -
External connect kit
(Optional parts)
CN410 UTY-XWZXZA
-
-