Fujitsu Airstage J-II Series Design & Technical Manual page 666

„ ADDRESS SETTING
„
z INDOOR UNIT ADDRESS SETTING
„
(7) Press the "MODE" button to access the
address setting mode.
(9) Press the "FAN" button to access the
address data setting mode. The address
data will flash once this button is pressed.
Address data
(11) Press the "START/STOP" button once to
send the information. A beeping noise will
be heard if the command is accepted.
In the following cases the setting signal is not read
¾
and a buzzer sounds.
The indoor unit address No. is set out of range
(64 or more) : Pi Pi Pi Pi Pi
The setting of the rotary switch on the PCB is not
"00" : Pi Pi Pi Pi Pi
z Confirmation of address setting
„
(13) Press the "TIMER set (+)" button.
"TIMER set (+)"
Pi Pi
Pi PiPiPi
PiPi
CORRECT : Pi PiPiPiPiPi
PiPi
WRONG: Pi (3 sec)
- (07 - 19) -
(8) Make sure the function number is '01'. If the
number is other than '01', press the "
the " " buttons to alter.
q
(10) Press the " " or the "
p
adjust the address data. The indoor unit
address range is between 00 and 63.
Each time the "MODE" button is pressed, it
switches between the one' place and the ten's
place positions.
Range
00 - 63
: UP
: DOWN
(12) Indoor unit will display the indoor unit
address data number on "TIMER
"(ORANGE) and "FILTER
OPERATION TIMER
(GREEN) (ORANGE)
continuously Flashing times of
address numbers
(the ten's place)
(Example) ADDRESS : 34
OPERATION LAMP
(GREEN)
0.5sec ON / 0.5sec OFF
TIMER LAMP
(ORANGE)
3 times
0.5sec ON / 0.5sec OFF
FILTER LAMP
(RED)
4 times
ADDRESS 0 setting will not indicate TIMER LAMP
¾
and FILTER LAMP.
" or
p
SET "01"
" buttons to
q
Change digit
"(RED) light.
FILTER
(RED)
Flashing times of
address numbers
(the one's place)
1 - 10 sec
1 - 10 sec