Fujitsu Airstage J-II Series Design & Technical Manual page 744

„ SWITCHING SELECTION OF FUNCTION SETTING MODE
„
3) When the [Function Setting] on the "Maintenance" screen is touched, the "Installer
Password Verification" screen is displayed.
Enter the Installer Password, and touch the [OK]. "Function Setting" screen is displayed.
Maintenance
Test Run
I.U. Address
Function Setting
Setting
Previous
Back
Page
„ FUNCTION SETTING
„
4) Touch the [Address] on the "Function
Setting" screen.
Function Setting
Address
Function No.
Setting No.
Back
6) Touch the [Function No.] on the "Function
Setting" screen.
Function Setting
Address
Function No.
Setting No.
Back
Page 2/ 3
R.C. Address
Setting
Next
Page
[002–01]
[00]
[00]
Setting
[002–01]
[00]
[00]
Setting
- (07 - 97) -
Function Setting
Address [002–01]
Function No.
Setting No.
Back Setting
Address setting mode initial display
5) "Address" screen is displayed. Select the
address of the indoor unit whose function
number is to be set by touching [▲] or [▼].
When setting at all the indoor units, touch
[All].
Address
002–01
Cancel
When the [OK] is touched, the display returns
to the "Function Setting" screen.
7) "Function No." screen is displayed. Set the
Function No. with the [▲] or [▼].
Function No.
30
Cancel
When the [OK] is touched, the display returns
to the "Function Setting" screen.
[00]
[00]
All
OK
OK