Fujitsu Airstage J-II Series Design & Technical Manual page 741

„ COMPLETION OF FUNCTION SETTING MODE
„
(13) Press and hold the "MANUAL/AUTO
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
Each LED may be of a different brightness, but the content
¾
of the message does not change.
¾ The function setting signal is not received after switched function setting completion mode. (Pi Pi Pi Pi Pi)
„
¾ Press the "MANUAL/AUTO
„
mode.
„ RECONFIRMATION OF FUNCTION SETTING
„
(15) Press and hold the "FAN" and the " SET
TEMP. " buttons. Whilst holding these 2
p
buttons, press the "RESET" button.
FAN
¾
SET TEMP. ( )
RESET
(16) Function number to be confirmed is displayed.
Refer to (7).
Press the "TIMER set (-)" button.
"TIMER set (-)"
Case1 : When setting number is one digit.
(Example) Function number : 30, Setting number : 01
0.5sec ON / 0.5sec OFF
OPERATION LAMP
(GREEN)
3 times
TIMER LAMP
(ORANGE)
0.5sec ON / 0.5sec OFF
FILTER LAMP
1 time
(RED)
(Phase1) : 12sec
"
Pi Pi Pi
MANUAL
AUTO
" button again for 3 sec to return to if required to return the function setting
Function setting
mode display
Case2 : When setting number is two digits.
...
3 times
OFF
...
1 time
(Phase1) : 12sec
- (07 - 94) -
(14) Press the "RESET" button.
After pressing the RESET
button, set the custom code
again if b,c,d setting.
RESET
(Example) Function number : 26, Setting number : 31
0.5sec ON / 0.5sec OFF
OPERATION LAMP
2 times
(GREEN)
0.5sec ON / 0.5sec OFF
TIMER LAMP
(ORANGE)
0.5sec ON / 0.5sec OFF 0.5sec ON / 0.5sec OFF
FILTER LAMP
1 time
(RED)
(Phase1) : 12sec
...
OFF
6 times
...
OFF
...
3 times
(Phase2) : 12sec