Fujitsu Airstage J-II Series Design & Technical Manual page 750

„ COMPLETION OF FUNCTION SETTING MODE
„
8) To clear the function setting mode and return to the regular display, hold down the three
buttons of SET TEMP. V, SET TEMP. Λ and FAN at the same time.
¾ If no key entry is made for 60 seconds, even though none of the above buttons is
„
pressed, the function setting mode will automatically be cleared.
(If the function setting mode is automatically cleared while setting addresses,
activate the mode again according to the procedure in step 3) above.)
„ SETTING UP EACH INDOOR UNIT
„
Indoor unit
01
Wired remote
controller
Repeat the procedures in steps 1) through 8), and set up the indoor units
requiring function setting.
„ RESET THE POWER AFTER SETTING UP FUNCTION OF ALL
„
INDOOR UNITS
Important
¾ If the reset is not performed, function cannot be read in normally.
„
¾ After all the functions have been set, the circuit breaker needs to be switched off
„
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
¾ The set function is stored in the PCB and will remain in memory even when the
„
power is turned off.
However, the address can be reset after power reset (if needed).
Record the function set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
Indoor unit Indoor unit
00 0 01 01 1 01 02 2
- (07 - 103) -
Normal mode display
Indoor unit Indoor unit
01 13 0 01
Wired remote Wired remote
controller controller
Indoor unit
14 1 01 15 0