Fujitsu Airstage J-II Series Design & Technical Manual page 815

● When electricity meter is connected
„
At electricity apportionment, the DX-Kit itself and units [A] and [B] mentioned above can be
handled the same as when an electricity meter is not connected. Set the electricity value at
ON beforehand for the units [A] and [B] from the "Parameter Setting" screen and install the
electricity meter so that the units [A] and [B] are included. The input value in the calculation as
a constant value when the external output value is ON is included.
DX-Kit
DX-Kit
If there is a unit related to the DX-Kit other than [A] and [B], if the DX-Kit is connected as an
independent electricity meter system and installed so that other units are included, it may be
included in electricity charge apportionment. (All the value of that electricity meter is charged
to the DX-Kit.)
DX-Kit
DDC/Damper/Heater, etc.
Whm
Units other than [A] and [B] must not be connected to an electricity meter together with other
indoor units. If connected, the electricity amount of DDC, damper and heater is also charged
to the other indoor units.
DX-Kit
DDC/Damper/Heater, etc.
Whm
[B] External fan
[A] Run/stop state
External output linked units
Whm
[B] External fan
[A] Run/stop state
External output
Whm
linked units
Whm
[B] External fan
[A] Run/stop state
External output linked units
Whm
[B] External fan
[A] Run/stop state
External output linked units
- (07 - 168) -
The electricity meter is installed so that the
units [A] and [B] are included.
The electricity meter is installed
independently from the units [A] and [B].
The electricity meter is installed so that [A],
[B], and other units are included.
The electricity meter is installed so that the
units other than [A], [B] and indoor units are
included.