Indoor Unit (Setting By Wireless Remote Controller) - Fujitsu Airstage J-II Series Design & Technical Manual

2-3. INDOOR UNIT (setting by wireless remote controller)

● This procedure changes to the function settings used to control the indoor unit according to
„
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
● After the power is turned on, perform the "FUNCTION SETTING" according to the
„
installation conditions using the remote controller.
● The settings may be selected from the following: Function Number or Setting Number.
„
● Settings will not be changed if disable numbers or setting numbers are selected.
„
„ PREPARATION
„
(1) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the pressure testing and vacuum drying
¾
have been conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power.
¾
Breaker ON
Indoor
units
- (07 - 89) -
Indoor
Indoor
units
unit