Xerox 480 ST System Administration Manual page 36

NOTE
NOTE
Page 3 - 8
c) Press the Host Name button.
d) When the soft keypad appears, type the SMB host name
EXACTLY as you want it to appear with proper case.
When finished press the Save button twice to record the
changes and exit to the TCP/IP Settings screen.
Subnet and Gateway.
7. To enter a Subnet Mask and Gateway Address.
a) Press the Subnet and Gateway button.
b) Press the soft buttons one at a time on the Touch Screen
for each Octet of the Subnet Mask and enter the numbers
from the keypad.
c) Repeat this process for the IP Gateway address. When
finished press Save to record the changes and exit to the
TCP/IP Settings screen.
d) Press the Close button.
The Broadcast Address will be calculated automatically.
8. To enable LP and LPR printing...
a) Press the TCP/IP - Line Printer button.
b) Press the Enable button.
While you can change the port number at which your Document
Centre will accept lpr print jobs it is recommended that you do this
ONLY with extreme caution as most lpr spoolers are set to send
print jobs to the default port.
c) If you wish to change the lpr port for your printer press
the Port Number soft button and enter the desired port
number at the keypad. Press Save.
Xerox Document Centre System Administration Guide