Table of Contents
Advertisement
NOTE
Xerox Document Centre System Administration Guide
Authentication Failure Generic Traps must be enabled on the
SNMP Properties Configuration Page before you can select it.
11. Click Apply New Settings to accept the changes or Restore
Settings to return the settings to their previous values.
To edit IP or IPX Trap Destinations:
1.
Open your Web browser and enter the TCP/IP address of the
Document Centre in the Address or Location field.
2.
Click the Properties tab or click Properties in the directory
tree.
3.
Select Connectivity, then select Protocols in the directory
tree.
4.
Select SNMP Configuration in the directory tree.
5.
Select an IP or IPX address in the Trap Destination Addresses
list.
6.
Click Edit.
7.
Make any changes to Traps to be Received.
8.
Click Apply New Settings to accept the changes or Restore
Settings to return the settings to their previous values.
To delete IP or IPX Trap Destinations:
1.
Open your Web browser and enter the TCP/IP address of the
Document Centre in the Address or Location field.
2.
Click the Properties tab or click Properties in the directory
tree.
3.
Select Connectivity, then select Protocols in the directory
tree.
4.
Select SNMP Configuration in the directory tree.
5.
Select one or more IP or IPX address in the Trap Destination
Addresses list.
6.
Click Delete.
7.
Click OK to confirm the deletion.
Page 16 - 63
Advertisement
Table of Contents
Troubleshooting
