Parallel Port - Xerox 480 ST System Administration Manual

NOTE
NOTE
Xerox Document Centre System Administration Guide

Parallel Port

If the parallel port is not in service, this page is unavailable.
To specify parallel port settings:
1. Open your Web browser and enter the TCP/IP address of the
Document Centre in the Address or Location field.
2. Click the Properties tab or click Properties in the directory
tree.
3. Select Connectivity, then select Physical Connections in the
directory tree.
4. Select Parallel in the directory tree.
5. Select Connection Enabled to enable the parallel port.
6. Type a Time-out in seconds. Valid entries are from 1-30 sec-
onds.
7. Click Apply New Settings to accept the changes or Restore
Settings to return the settings to their previous values.
The settings are not applied until you restart the Document Centre.
Page 16 - 47