Parallel Port Configuration; To Access Parallel Port Settings At The Device; Port Status (Parallel Port Enablement) - Xerox WorkCentre 7300 Series Administrator's Manual

Hide thumbs Also See for WorkCentre 7300 Series:
Table of Contents

Advertisement

Parallel Port Configuration

To view or change the settings of the Device's parallel port, perform the following steps:
Note: You must have purchased the Parallel (1284) Printing kit and installed the supplied hardware
before you can configure this port.

To access Parallel Port Settings at the Device

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Port Settings.
8. Press the line labeled Parallel on the Port Settings menu.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the Parallel Port selections menu displays, note that you have a choice of setting selections by
numbered horizontal lines, with the current status of each setting shown. The up and down arrow keys
provide access to additional selections and return you to the current selections display. The Close
button in the upper right corner of the screen returns you to the Port Settings menu. After pressing a
horizontal line selection, to access available settings press the Change Settings button in the lower
right corner of the touch screen.

Port Status (Parallel Port Enablement)

1. On the Parallel Port selections menu, press the selection line labeled Port Status.
2. Press the Change Settings button.
3. On the Parallel Port Status screen, note which of the two buttons is highlighted as the current setting
for Parallel Port Enablement. The available settings are Enabled or Disabled.
4. To change settings, press your setting of choice, then click the Save button on the touch screen.
5. To exit the screen, without making any changes, click the Cancel button on the touch screen.
7

Advertisement

Table of Contents
loading

Table of Contents