Table of Contents
Advertisement
WARNING
If the suspension has been modified or
●
tires of a size other than specified are
installed
If the front of the vehicle is raised or
●
lowered due to the carried load
When equipment that may obstruct a
●
sensor is installed, such as a towing
eyelet, bumper protector (an addi-
tional trim strip, etc.), bicycle carrier,
or snow plow
●
When using an automatic car wash
■
The Parking Support Brake function
(static objects) will operate when
The function will operate when the PKSB
OFF indicator is not illuminated or flashing
(P.69, 70) and all of the following condi-
tions are met:
Engine output restriction control
●
• The Parking Support Brake is enabled.
• The vehicle speed is 10 mph (15 km/h) or
less.
• There is a static object in the traveling
direction of the vehicle and 6 to 13 ft. (2
to 4 m) away.
• The Parking Support Brake determines
that a stronger-than-normal brake oper-
ation is necessary to avoid a collision.
Brake control
●
• Engine output restriction control is oper-
ating.
• The Parking Support Brake determines
that an immediate brake operation is
necessary to avoid a collision.
■
The Parking Support Brake function
(static objects) will stop operating when
The function will stop operating if any of the
following conditions are met:
●
Engine output restriction control
• The Parking Support Brake is disabled.
• The system determines that the collision
has become avoidable with normal brake
operation.
• The static object is no longer 6 to 13 ft. (2
to 4 m) away from the vehicle or in the
traveling direction of the vehicle.
4-5. Using the driving support systems
Brake control
●
• The Parking Support Brake is disabled.
• Approximately 2 seconds have elapsed
since the vehicle was stopped by brake
control.
• The brake pedal is depressed after the
vehicle is stopped by brake control.
• The static object is no longer 6 to 13 ft. (2
to 4 m) away from the vehicle or in the
traveling direction of the vehicle.
Re-enabling the Parking Support Brake
■
function (static objects)
P.236
■
Detection range of the Parking Support
Brake function (static objects)
The detection range of the Parking Support
Brake function (static objects) differs from
the detection range of the intuitive parking
assist. (P.225) Therefore, even if the
intuitive parking assist detects an object and
provides a warning, the Parking Support
Brake function (static objects) may not start
operating.
Objects that the Parking Support Brake
■
function (static objects) may not detect
The sensors may not be able to detect cer-
tain objects, such as the following:
Pedestrian
●
●
Cotton cloth, snow, and other materials
that are poor reflectors of ultrasonic
waves
Objects which are not perpendicular to
●
the ground, are not perpendicular to the
traveling direction of the vehicle, are
uneven or are waving
●
Low objects
Thin objects such as wires, fences, ropes
●
and signposts
Objects that are extremely close to the
●
bumper
Sharply-angled objects
●
Tall objects with upper sections project-
●
ing outwards in the direction of your vehi-
cle
239
4
Advertisement
Table of Contents
