Table of Contents
Advertisement
310
6-1. Maintenance and care
WARNING
Lexus Safety System + 2.0
●
BSM (if equipped)
●
RCTA (if equipped)
●
PKSB (if equipped)
●
NOTICE
To prevent paint deterioration and
■
corrosion on the body and compo-
nents (aluminum wheels, etc.)
Wash the vehicle immediately in the
●
following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the
paint surface
• If dead insects, insect droppings or
bird droppings are present on the
paint surface
• After driving in an area contaminated
with soot, oily smoke, mine dust, iron
powder or chemical substances
• If the vehicle becomes heavily soiled
with dust or mud
• If liquids such as benzene and gasoline
are spilled on the paint surface
●
If the paint is chipped or scratched,
have it repaired immediately.
To prevent the wheels from corroding,
●
remove any dirt and store in a place
with low humidity when storing the
wheels.
Cleaning the exterior lights
■
●
Wash carefully. Do not use organic
substances or scrub with a hard brush.
This may damage the surfaces of the
lights.
●
Do not apply wax to the surfaces of the
lights.
Wax may cause damage to the lenses.
■
When using an automatic car wash
(vehicles with rain-sensing windshield
wipers)
Set the wiper switch to the off position.
If the wiper switch is in AUTO, the wipers
may operate and the wiper blades may
be damaged.
■
When using a high pressure car wash
When washing the vehicle, do not let
●
water of the high pressure washer hit
directly or the vicinity of the camera.
Due to the shock from the high pres-
sure water, it is possible the device
may not operate as normal.
Do not bring the nozzle tip close to
●
boots (rubber or resin manufactured
cover), connectors or the following
parts. The parts may be damaged if
they come into contact with high-pres-
sure water.
• Traction related parts
• Steering parts
• Suspension parts
• Brake parts
Keep the cleaning nozzle at least 11.9
●
in. (30 cm) away from the vehicle
body. Otherwise resin section, such as
molding and bumpers, may be
deformed and damaged. Also, do not
continuously hold the nozzle in the
same place.
●
Do not spray the lower part of the
windshield continuously. If water
enters the air conditioning system
intake located near the lower part of
the windshield, the air conditioning
system may not operate correctly.
Do not wash the underside of the vehi-
●
cle using a high pressure car washer.
Advertisement
Table of Contents
