Table of Contents
Advertisement
396
8-1. Specifications
Lubrication system
Oil capacity (Drain and refill [Ref-
■
*
erence
])
With filter
4.9 qt. (4.6 L, 4.0 Imp.qt.)
Without filter 4.5 qt. (4.3 L, 3.8 Imp.qt.)
*
: The engine oil capacity is a reference
quantity to be used when changing the
engine oil. Warm up and turn off the
engine, wait more than 5 minutes, and
check the oil level on the dipstick.
Engine oil selection
■
"Toyota Genuine Motor Oil" is used in
your Lexus vehicle. Use Lexus
approved "Toyota Genuine Motor
Oil" or equivalent to satisfy the follow-
ing grade and viscosity.
Oil grade: API SN/RC multigrade
engine oil
Recommended viscosity: SAE 0W-16
Outside temperature
A
SAE 0W-16 is the best choice for
good fuel economy and good starting
in cold weather.
If SAE 0W-16 is not available, SAE
0W-20 oil may be used. However, it
must be replaced with SAE 0W-16 at
the next oil change.
Oil viscosity (0W-16 is explained here
as an example):
• The 0W in 0W-16 indicates the
characteristic of the oil which allows
cold startability. Oils with a lower
value before the W allow for easier
starting of the engine in cold
weather.
• The 16 in 0W-16 indicates the vis-
cosity characteristic of the oil when
the oil is at high temperature. An oil
with a higher viscosity (one with a
higher value) may be better suited if
the vehicle is operated at high
speeds, or under extreme load con-
ditions.
How to read oil container label:
API registered mark is added to some
oil containers to help you select the oil
you should use.
Advertisement
Table of Contents
