Table of Contents
Advertisement
50
1-2. Child safety
2
If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
restraint.
3
Place the child restraint system on
the seat facing the front of the vehi-
cle.
4
Run the seat belt through the child
restraint system and insert the plate
into the buckle. Make sure that the
belt is not twisted.
5
Fully extend the shoulder belt and
allow it to retract to put it in lock
mode. In lock mode, the belt cannot
be extended.
6
While pushing the child restraint
system into the rear seat, allow the
shoulder belt to retract until the
child restraint system is securely in
place.
After the shoulder belt has retracted to a
point where there is no slack in the belt,
pull the belt to check that it cannot be
extended.
7
If the child restraint has a top tether
strap, follow the child restraint
manufacturer's operation manual
regarding the installation, using the
top tether strap to latch onto the
top tether strap anchor. (P.54)
8
After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
Advertisement
Table of Contents
