Table of Contents
Advertisement
302
5-6. Using the other interior features
does not operate, proceed to "Pro-
gramming a rolling code system".
5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
3
Perform
within 30 seconds after
performing 2.
3
®
buttons.
■
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
device compatibility, refer to
www.homelink.com.)
1
Press and hold the desired
®
HomeLink
button (inside the
vehicle) for 2 seconds and release
it. Repeat this sequence
(press/hold/release) up to 3 times
to complete programming.
If the garage door opener motor
operates when the HomeLink
button is pressed, the garage door
opener motor recognizes the
®
HomeLink
signal.
Enabling 2-way communication
with a garage door (only available
for compatible devices)
Within 5 seconds after program-
ming the garage door opener has
been completed, if the garage door
opener motor is trained to
®
HomeLink
, both garage door
operation indicators will flash rap-
idly (green) and the light on the
®
Advertisement
Table of Contents
