Table of Contents
Advertisement
etc. Clean the lock sensor and attempt to
operate it again.
●
A sudden approach to the effective
range or door handle may prevent the
doors from being unlocked. In this case,
return the door handle to the original
position and check that the doors unlock
before pulling the door handle again.
●
If there is another electronic key in the
detection area, it may take slightly longer
to unlock the doors after the door handle
is gripped.
When the vehicle is not driven for
■
extended periods
●
To prevent theft of the vehicle, do not
leave the electronic key within 6 ft. (2 m)
of the vehicle.
The smart access system with push-but-
●
ton start can be deactivated in advance.
●
Setting the electronic key to battery-sav-
ing mode helps to reduce key battery
depletion. (P.115)
To operate the system properly
■
Make sure to carry the electronic key when
operating the system. Do not get the elec-
tronic key too close to the vehicle when
operating the system from the outside of
the vehicle.
Depending on the position and holding
condition of the electronic key, the key may
not be detected correctly and the system
may not operate properly. (The alarm may
go off accidentally, or the door lock preven-
tion may not operate.)
If the smart access system with push-
■
button start does not operate properly
If the doors cannot be locked or
●
unlocked, perform the following.
• Bring the electronic key close to the door
handle and perform a lock or unlock
operation.
• Use the wireless remote control.
If the doors cannot be locked or unlocked
by perform the above, use the mechanical
key. (P.384)
For Canada: However, if the mechanical
key is used while the alarm system is set, the
3-2. Opening, closing and locking the doors
warning will sound. (P.63)
If the engine cannot be started, refer to
●
P.385
Customization
■
Settings (e.g. smart access system with
push-button start) can be changed. (Cus-
tomizable features: P.415)
If the smart access system with push-button
start has been deactivated by a customized
setting, refer to the explanations for the fol-
lowing operations.
Locking and unlocking the doors:
●
Use the wireless remote control or
mechanical key. (P.98, 384)
●
Starting the engine and changing engine
switch modes: P.385
Stopping the engine: P.153
●
117
3
Advertisement
Table of Contents
