Installing The Detector - Agilent Technologies G1314B User Manual

Installing the Detector

Parts required #
1
1
1
1
1
For other cables see below and section
Instant Pilot (G4208A) is optional.
Preparations Other LC modules must have appropriate firmware installed to work with the detector.
• Locate bench space.
• Provide power connections.
• Unpack the detector.
Before adding the detector into an existing system assure that the existing modules have
N O T E
been updated to firmware revision that is supported by the control software.
1 Install the LAN interface board in the detector (if required), see
2 Place the detector in the stack or on the bench in a horizontal position.
Agilent 1260 Infinity VWD User Manual
p/n
G4208A
"Replacing the Interface Board"
Description
Detector
Power cord
LAN cable (cross-over or twisted pair network cable)
Agilent ChemStation or other control software
Instant Pilot
"Cable Overview"
on page 134

Installing the Detector

Installing the Detector
on page 152.
3
43